Wednesday, August 17, 2016

Schematic and teardown of BAKU 858D SMD Rework station

General description

If you're familiar with SMD soldering, you probably know about the 858 series of chinese-made, el-cheapo SMD rework stations. There are probably tens of small companies manufacturing these stations (Atten, Baku, Scotle, YOUYUE, KADA, W.E.P, Saike, YIHUA, BEST, Quick, etc.). Of course, on the exterior they almost all look the same. The internals are quite different though, some of them use the Mikkon MK1841D3 microcontroller (which according to a thread over at eevblog is a clone of Samsung S3F9454), a Holtek HT46R23 or an AVR MCU.

The AVR-based ones are much better value since they're reprogramable, but there's no way to tell which station uses which MCU based on their looks. One model known to use an Atmega8 MCU is the Youyue 858D+.

BAKU 858D SMD rework station

Unfortunately mine ( BAKU 858D ) uses the MK1841D3 which is an OTP (one-time programmable) MCU so there is no way to tinker with it or write my own firmware. On the more positive side, it works quite well as-is, except for some minor quirks, like the temperature overshoot when turning it on and the overall quality of the components.

Recently the power button from my unit has broken off so I opened it up to replace it and also made some pictures of the interior. Hopefully these will help someone make a general idea of this model's quality and also help compare it with other "brands".


PCB reverse. Please note the crapacitors.

Front of the PCB. Nothing fancy over here either

The main transformer. 2 windings, one for the fan (25V) and one for the controller (10V)

One nice thing about these units is that they use a centrifugal fan instead of the membrane air pump like the older stations from Gordak. There is much less noise and vibration, not to mention they're more reliable. There's no heat generated inside and they can provide good airflow, up to 120 l/min (compared to 24 l/min for diaphragm pumps).


The blower fan
Both the heater and the fan are located in the hot air wand, an improvement over the older stations. This way the unit case is smaller since it only hosts the control circuitry and the transformer.

Wiring in the hot air wand

The heating element connections and the reed switch

The schematic

I had a little bit of free time so, as an exercise of patience I have reverse engineered the PCB and made a schematic for this unit. At the time of writing this, this is the only complete schematic for this model (Baku 858D, 858D04.PCB from 2014.06.09). The main reason for drawing it is for future troubleshooting. An interesting idea would be to modify the schematic to work with an AVR instead of the Mikkon MCU. The rest of the circuit seems to be well designed, no modifications are required.

Note that the schematic drawing might have mistakes. It comes without any warranty of any kind, use it at your own risk.


858D schematic part 1

858D schematic part 2

858D schematic parts list

Conclusion

All in all, this type of rework station is quite decent, I recommend it over the old Gordak stations which were noisy and bulky. What I don't recommend is getting this exact model. If you want to buy an 858D, find one which is better built by looking at the comments on the seller's site. Maybe a Youyue 858D+ would be the best choice (since it uses an Atmega8 MCU).